Install IDE Drive Vertically?
I had it on top of the PC case connected with a USB cable trying to back up the vacation trips I had on it. Is it suggestd to plug them into secondary slot? Try to keep your CD-ROM either on a separate channel, or as a slave. 2. The fact that NONE of the spec sheets I've ever seen mentions orientation should be a pretty strong clue that it's irrelevant.And "clicking" is a pretty normal sound that a lot Check This Out
For your desktop, companies such as StarTech, Buffalo, Rosewill and others can provide a reasonably priced x1 PCI card that will have you up and running in the time it takes Make sure the drive with the operating system is listed there with perhaps an optical drive or floppy drive before it. Reply to pamipa AnonymousApr 25, 2010, 10:00 PM Mount the drive in the systemDesktop Drives: The drive can be mounted in a standard 3.5"device bay. But we need your help.
Hard Drive Orientation
Some tests with early laptops on the shuttle showed that the seek time was a little bit faster, possibly because the seek motors didn't have to move as much weight. Can anybody tell if there is some wearing in vertical position compared to horizontal? So you can fix the stuff you own quickly—and get back on with your life.
IDE drives are identified as either the Master or Slave drive depending on the location on the IDE cable and/or jumper selection at the back of the drive. This prevents the drive from shooting out of the front of the computer when the spring-retention force is overcome, thus propelling the new drive across the room. I ran CHKDSK, SpinRite, and other tools on these drives and received no errors, so again decided just to wait and see. Changing Hard Drive Orientation Reply to ahem cjlAug 19, 2009, 3:10 PM I doubt it would affect longevity at all, and I'd be quite surprised if any manufacturer had any issues at all.
PSU with bottom/top fan mounted upside down on top of case? Hard Drive Upside Down I lust thought I would share my observation with you November 10, 2012 Menace Up till now, ALL vertically mounted drives have crashed within the waranty period. You should be able to remove a jumper with your finger nails, if not then use a pair of very small needle nose pliers and don’t bend the pins. It may require significant pressure to get the power connector to seat, so use care to avoid hurting your fingers if the connector seats suddenly.
Click the Advanced Settings tab to display the dialog. Hard Drive Which Side Up Ye, the pata cables sure looked fine with HDD bend 90 degree.. Sideways orinatation is common inside many smaller cases too.Upside down is fine as long as its mounted just as secure. Isnt this true?
Hard Drive Upside Down
All rights reserved. https://discussions.apple.com/thread/566397?start=0&tstart=0 who knows? Hard Drive Orientation This is why I did. Seagate Hard Drive Upside Down Yeah, nothing wrong with drives on their sides.
But off course it isn't. http://secondsolution.net/hard-drive/install-second-hard-drive.php Thanks. The actual connector of IDE can allow for more than one device so there are some cables with more than one device end on them, while SATA is one-to-one. and 3.5-in. Mounting Hard Drive Upside Down
The more surface and/or air(speed) the better. Erased the Disk, to Mac OS X E - and it appeared to erase - but - still no mount...I have erased the Disk too... Closer look: Two hard drives and one optical drive are shown in this guide. this contact form Many of us at TPU probably remember trying to make IDE cables look good for drives in the more common horizontal orientation - it didn't always happen Same could be said
Samsung: As long as it is securely attached to the chassis, hard disk drives may be mounted either horizontally or vertically depending on how your computer's case is constructed.
Processor: Intel i5-2500k - 4.4GHz @ 1.3v Motherboard: ASUS Maximus IV Extreme-Z (z68) Cooling: HSF:: Noctua NH-D14 || CASE:: 2x Intake: Noctua NF-P12-1300 | 2x Exhaust: Noctua NF-S12B Memory: G.Skill RipJaws Assigning the highest available drive letter, Z, to the optical drive prevents Windows from ever altering that drive letter. This site is completely free -- paid for by advertisers and donations. Sata Cable Hmmm.
It just doesn't seem right to me. Orientation of the harddrive cannot be considered a realistic factor in computer life expectancy. The Drives & Jumper Settings Whether it’s a CD-ROM drive or hard disk, IDE drives are identical in terms of connectors. navigate here That's all there is to installing an optical drive.
For example, Figure 8-7 shows that the DVD-ROM drive installed as the master device on the secondary ATA channel is using Ultra DMA Mode 2, which is the fastest DMA mode Maxtor: The hard drive can be mounted in any orientation. If you have an ExpressCard slot in your laptop, four-port SuperSpeed USB 3.0 Front Panel Hub that fits into a 3.5-inch bay and can be found online for as low as Related: Data Center Computer Hardware 1 2 3 Page 1 Next Prices still climbing for enterprise mobility management software You Might Like Shop Tech Products at Amazon What Readers Like The
SATA drives can simply be attached before heading to the BIOS while IDE drives must be installed slightly different. Figure 8-4: Connecting an ATA data cable to an optical drive When Slow Is Fast Enough Because optical drives have relatively slow data transfer rates, they can use the standard 40-wire Every other time I've heard this sort of sound, is was accompanied by more serious problems, such as the drive coming and going or not being visible at all in Windows, Drive cloning in Windows 10 with free tools The IT-business gap remains 10 ways tech pros can take charge of their professional development Review: Microsoft's Nano Server offers mega advantages More
November 8, 2012 Joel I'm not too sure if this really answers the question. No, create an account now. Reply to teknokratus sminlalNov 23, 2009, 2:21 AM There really, really isn't any difference running a hard drive "right" side up, down, left or right. November 10, 2012 Bernard In seventeen years I have only had one hard drive fail.
Here are the latest Insider stories. IDE Cables Let’s look at some standard IDE cables and connectors. LCD Mounting Upside down Upside-down mounting of PS solved Can I mount my PSU upside down My Axess 7" TV is upside down because I want to mount it under a If the Current Transfer Mode box for the drive now displays DMA mode, the drive is now using DMA.
And if you want to change drives, you just eject the current device (the way you would a flash drive) and pop in the new one. Tell them repair is good for the environment, good for consumers, and good for businesses. So far, so good. Verify that the pin 1 side of the cable, usually indicated with a red or other colored stripe, corresponds to pin 1 on the drive connector.
If after installing the drive(s) the system does not boot properly into the operating system (if one is already installed), go into the BIOS and check the Boot Device Priority. The top of the drive will stay very cool, but who cares?! Why Are Most Programs Still 32-bit on a 64-bit Version of Windows? 10 Quick Ways to Speed Up a Slow PC Running Windows 7, 8, or 10 How to Choose the You will begin to hear that more and more frequently...