Home > Hard Drive > Installed New Hard Drive. Accidently Unplugged Two Extra Wires.

Installed New Hard Drive. Accidently Unplugged Two Extra Wires.

Contents

Solution: Make sure that the system hardware is getting only the required power supply. And they get to set whatever prices they want. Robert Wacker - 04/02/2014 Reply Great tutorial. I've tried every fan control software out there, and nothing works; the fan just constantly runs. Check This Out

Any ideas? As you said, you've purchased 3 years ago, I strongly suspect that hard drive has developed some aging equipment's i.e. klaubscher326 - 02/23/2014 Reply When removing the wifi antenna make sure you use a plastic spudger and lever up underneath the wire. After reboot restore from your old disk and Bob's your Uncle.

Accidentally Unplugged External Hard Drive

physical or logical errors on a hard drive, not the formatting process though. If the drive is put into its place with this bracket slid toward the front (opening) of the drive, there is danger the bracket may be bent, causing the problem I Gold subscriber Administrator Posts: 46542 Joined: Tue Aug 20, 2002 10:51 pm Location: Somewhere, having a beer Re: Installed New Hard Drive = Black Screen Quote #20 Sat May 17, 2014 First of all, replace or change the SATA/USB cable as well as power adapter.

It seems to be a T5. Seems like people have had success and failures with either position? If it's completely black or the monitor shows "no signal" then something has been dislodged in the case. Unplugged Hard Drive While Running However, if you are planning just to add a second driver, there is no need for the doubler kit (only a new lower flex drive).

xtian - 06/24/2009 Reply As an addition to xtian's note, the bracket that you need to slide right (and a spudger is very useful here) it may be because the rear Backup or copy entire data from the old hard drive to new one and then destroy the old hard drive carefully. Sourav Gupta June 6, 2013 my hard disk On my machine (refurbished Mac Mini late 2012 purchased October 2013) the hard drive was in the "lower" slot, and was firmly screwed in to a holding post. Starts with checking power supply and make sure that it's not the issue.

Martin Cleaver - 08/11/2013 Reply For reassembly, note that the red T8/2mm hex screw doesn't screw all the way down. Did Not Safely Remove External Hard Drive I have a Samsung 850 Evo and a Sandisk Z400s and for some reason I can't format, partition, erase, or install the OS on either internally, which always results in an Hans Erik Hazelhorst - 02/01/2014 Dismantling the Mini was simple, but the two hardest steps when installing a new hard drive were sliding the drive back in aligned correctly, and replacing Success!

Unplugged External Hard Drive Accidentally Mac

Manufacturers like Apple are standing in the way. https://www.ifixit.com/Guide/MacBook+Pro+13-Inch+Unibody+Mid+2012+Hard+Drive+Cable+Replacement/10379 I was enjoying Fifa 13 and PES 13 games which I bought from roadside CD vendors and those were running perfectly. Accidentally Unplugged External Hard Drive Add a comment Add a comment Add Comment 1024 Step 14 Edit Remove the two Phillips screws from the front edge of the optical drive. Unplugged External Hard Drive Without Ejecting The hard drive cable also contains the sleep LED and the IR sensor.

Tim Davenport - January 1 Reply Add a comment Add Comment 1024 Almost done! http://secondsolution.net/hard-drive/installed-a-new-hard-drive.php eric - 12/05/2016 Reply Add a comment Add Comment 1024 Step 22 Edit Slide the power supply out of the mini, minding any cables that may get caught. 2 comments Specifically, On reboot, the system would detect the drive and give me normal access to the contents. manwe - 02/09/2015 Reply I had the same problem as Roman, I just figured I would add that those "two screws" are T8 screws and that there is a cable on External Hard Drive Unplugged During Transfer

klaubscher326 - 02/23/2014 Reply When removing the wifi antenna make sure you use a plastic spudger and lever up underneath the wire. Great job ifixit.com! If there is no pull-tab on the top of the connector, it may be helpful to use a spudger to disconnect this connector. 2 comments The display cable was difficult to http://secondsolution.net/hard-drive/installed-new-hard-drive.php no i never did couldn't get help it blows to hear someone else had the same problem...im using a windows(yuk) but im getting a new mac next paycheck.

Also, Take care removing the RAM out of its packet, DO NOT touch the Gold connectors, and hold the RAM by the edges. Accidentally Ejected Internal Hard Drive Windows It starts as soon as I boot up. Nick Michielsen - 11/30/2012 Reply Did it just as Nick suggested, hang the assembly to the side.

Flag Permalink This was helpful (0) Collapse - Unable to access hard drive.

Bought the i7 model off Craigslist from a student. Craig Reilly - 11/25/2015 I needed a T7 for this, and had to remove all three screws before I could take the fan out. Through process of elimination I figured it was the hard drive cable. Accidentally Unplugged Internal Hard Drive Thanks a million for the guide (and the extra comments attached to most of the steps)!

SHOW ME NOW CNET © CBS Interactive Inc.  /  All Rights Reserved. philomathius - 05/15/2012 Reply You can also use the probes from a Digital Multi-Meter. Do you hav any idea? navigate here If you don't have a magnetized screwdriver, load up a stick of gum and chomp on it until it's needed then use a bit to retain screw on the driver.

fasthans - 12/08/2014 Reply Prying the battery connector off does not take much force. Top Chrispy_ Silver subscriber Grand Gerbil Poohbah Posts: 3765 Joined: Fri Apr 09, 2004 3:49 pm Location: Europe, most frequently London. Then I realized there's a little tiny "o-ring" underneath which is acting like a nut. Tell them repair is good for farmers, good for consumers, and good for businesses.

Alex - 08/08/2014 Reply The likely problem with your wifi is not the card but the antenna leads that go into the plastic clutch . davidebarta - 11/22/2015 Reply Great guide. skraggle - 11/13/2009 Reply Just R&R'ed the fan in my black MacBook Core 2 Duo tonight. I used a metal screwdriver and levered up from the side opposite the wire and ripped the pico-ITX connector right off the board!

Shy away from the brute force - it's the surest way to damage something. Two holes on the underside of the enclosure should align with two attachment holes on the underside of the drive. NEWS BREADBOX PODCASTS BLOGS SYSTEMS MULTIMEDIA MISCELLANY ARCHIVE ABOUT US Search… Search Search… Search Quick links Unanswered topics Active topics Search The team Forum FAQ New posts Unread posts Active topics This will fit the 4 screws more properly in the steel inner-frame and they can come a little bit loose.

Therefore, take backup ASAP and replace it with any new hard drive from trusted supplier. Calvin - 04/15/2010 Reply Quote from Calvin: My battery does not pop out when after step 1. Do the fans (CPU, GPU, PSU, case) spin at all?4. R-Studio Data Recovery Software can first copy the entire disk or its part into an image file and then process the image file.

I didn't use my laptop often. FinnCrisp888 - 12/30/2012 Reply That screw is a post at that point. rob545 - 09/21/2013 Reply Add a comment Add Comment 1024 Step 29 Edit Use the edge of the SSD connector to put a 90 degree downward bend in the cable along To reassemble your device, follow these instructions in reverse order.

Flag Permalink This was helpful (0) Collapse - Even bigger problem with it being a linux install by darrenforster99 / July 3, 2010 7:27 PM PDT In reply to: REPLY -